How to use your BeautyGlo Repair & Renew Microderm Pro
Please read all instructions before using your device.
STEP #1 - CLEANSE
Start your treatment by cleansing and rinsing all dirt and makeup off the area.
STEP #2 - CHOOSE YOUR SUCTION HEAD
Choose the head you will use based on the results you would like to achieve.
We recommend you start with the:
Best for extracting dirt and oil while exfoliating the outer layer of skin. Leaving your skin to regenerate and reveal its inner glow.
Best for removing blackheads or whiteheads from the tip of the nose, chin or other sensitive areas.
Best for reducing wrinkles on the forehead and cleansing hard to reach areas such as the crevice of your nose.
Best for enhancing blood circulation and stubborn blackheads. This head has the strongest suction so please check device settings before utilizing Level 3 suction with this head.
STEP #3 - TEST THE SUCTION
To avoid bruising and make sure the device is at a comfortable setting please ensure you use the right power level and technique.
Test the suction level, glide and stroke angle across the back of your hand. After 5 minutes have passed, you are safe to use the device on your face.
STEP #4 - OPEN YOUR PORES
To obtain optimal results make sure to open your pores by using a face steamer, taking a hot shower or using a warm towel on your face for 10 minutes.
STEP #5 - SET THE POWER LEVEL
Always start with the lowest setting and slowly increase if you need more suction power. Level 3 should only be used for non-sensitive parts of your body.
STEP #6 - MICRODERMABRASION TIME
Follow the User Manual that comes with the device for a guide on how to use the device for optimal results.
Here is a quick list of rules you should follow:
The suction should never feel too strong.
Do not apply any pressure while using your device.
Do not keep the device in one area to avoid bruising.
Slowly guide the device over your skin while pulling it taunt.
Never go over an area more than once.
If you feel any pain during the treatment, stop immediately. This is a sign that you have selected a suction level which is not suitable for your skin type, stayed on one area for too long, glided the device too slow or have gone over an area more than once.
STEP #7 - SONIC VIBRATION
Choose Sonic Vibration between two temperature settings for added benefits:
Heat Setting: Promote blood circulation and infuse serum into your skin.
Cool Setting: Close Pores, tighten skin and reduce puffiness under your eyes.
STEP #8 - CLEAN YOUR DEVICE
Please make sure to wipe down the vibration side and wash the suction head with warm soapy water and an alcohol based disinfectant. This will prevent breakouts and bacteria build up, prolonging the life of your BeautyGlo Microderm Pro.
STEP #9 - CHARGE YOUR DEVICE
Replace the device onto the dock, a red light indicates charging and a green light indicates a full charge.